.Modelica.Mechanics.Rotational.Sources.Move

Information

Flange flange is forced to move relative to flange support with a predefined motion according to the input signals:

    u[1]: angle of flange
    u[2]: angular velocity of flange
    u[3]: angular acceleration of flange

The user has to guarantee that the input signals are consistent to each other, i.e., that u[2] is the derivative of u[1] and that u[3] is the derivative of u[2]. There are, however, also applications where by purpose these conditions do not hold. For example, if only the position dependent terms of a mechanical system shall be calculated, one may provide angle = angle(t) and set the angular velocity and the angular acceleration to zero.

The input signals can be provided from one of the signal generator blocks of the block library Modelica.Blocks.Sources.


Generated at 2020-06-05T07:38:22Z by OpenModelica 1.16.0~dev-420-gc007a39