This information is part of the Modelica Standard Library maintained by the Modelica Association.

The step source output signal steps from the value before to the value after at the time stepTime.

To specify the logic value parameters, the integer code has to be used.

Code Table

Logic value	Integer code	Meaning
'U'	1	Uninitialized
'X'	2	Forcing Unknown
'0'	3	Forcing 0
'1'	4	Forcing 1
'Z'	5	High Impedance
'W'	6	Weak Unknown
'L'	7	Weak 0
'H'	8	Weak 1
'-'	9	Do not care

If the logic values are imported by
import L = Digital.Interfaces.Logic;
they can be used to specify the parameter, e.g., L.'0' for forcing 0.

before	Value: Type: Logic Description: Logic value before step
after	Value: Type: Logic Description: Logic value after step
stepTime	Value: Type: Real Description: step time