PartialPressureLossBase flow model for pressure loss functions with the same area at port_a and at port_b |
allowFlowReversal |
Value: system.allowFlowReversal Type: Boolean Description: = true to allow flow reversal, false restricts to design direction (port_a -> port_b) |
---|---|
dp_start |
Value: 0.01 * system.p_start Type: AbsolutePressure (Pa) Description: Guess value of dp = port_a.p - port_b.p |
m_flow_start |
Value: system.m_flow_start Type: MassFlowRate (kg/s) Description: Guess value of m_flow = port_a.m_flow |
m_flow_small |
Value: if system.use_eps_Re then system.eps_m_flow * system.m_flow_nominal else system.m_flow_small Type: MassFlowRate (kg/s) Description: Small mass flow rate for regularization of zero flow |
show_T |
Value: true Type: Boolean Description: = true, if temperatures at port_a and port_b are computed |
show_V_flow |
Value: true Type: Boolean Description: = true, if volume flow rate at inflowing port is computed |
port_a |
Type: FluidPort_a Description: Fluid connector a (positive design flow direction is from port_a to port_b) |
|
---|---|---|
port_b |
Type: FluidPort_b Description: Fluid connector b (positive design flow direction is from port_a to port_b) |
system |
Type: System Description: System wide properties |
|
---|---|---|
state_a |
Type: ThermodynamicState Description: state for medium inflowing through port_a |
|
state_b |
Type: ThermodynamicState Description: state for medium inflowing through port_b |
|
state_dp_small |
Type: ThermodynamicState Description: Medium state to compute dp_small |
Modelica.Fluid.Fittings.Orifices Thicked edged orifice flow model |
|
Modelica.Fluid.Fittings.Bends Edged bend flow model |
|
Modelica.Fluid.Fittings.Bends Curved bend flow model |