Modelica.Electrical.Spice3.Interfaces

Connectors, Interfaces, and partial models

Information

The SPICE3 package uses the Modelica.Electrical.Analog interfaces. Only special partial models used in the SPICE3 package are located in this Interfaces package.

Extends from Modelica.Icons.InterfacesPackage (Icon for packages containing interfaces).

Package Content

Name	Description
TwoPortControlledSources	Component with two electrical ports, including current
InductiveCouplePinIn	Pin to couple inductances via K, which gets the value of inductance
InductiveCouplePinOut	Pin to couple inductances via K, which sets the value of inductance
ConditionalSubstrate	Partial model to include a conditional substrate node

Modelica.Electrical.Spice3.Interfaces.TwoPortControlledSources

Component with two electrical ports, including current

Information

TwoPort is a partial model that consists of two ports. It is assumed that the current flowing into the positive pin is identical to the current flowing out of pin n. This currents of each port are provided explicitly as currents i1 and i2, the voltages respectively as v1 and v2.

Connectors

Modelica.Electrical.Spice3.Interfaces.InductiveCouplePinIn

Pin to couple inductances via K, which gets the value of inductance

Contents

Modelica.Electrical.Spice3.Interfaces.InductiveCouplePinOut

Pin to couple inductances via K, which sets the value of inductance

Contents

Modelica.Electrical.Spice3.Interfaces.ConditionalSubstrate

Partial model to include a conditional substrate node

Information

This partial model provides a conditional heating port for the connection to a thermal network.

• If useHeatPort is set to false (default), no heat port is available, and the thermal loss power flows internally to the ground. In this case, the parameter T specifies the fixed device temperature (the default for T = 20^oC).
• If useHeatPort is set to true, a heat port is available.

If this model is used, the loss power has to be provided by an equation in the model which inherits from ConditionalHeatingPort model (lossPower = ...). As device temperature T_heatPort can be used to describe the influence of the device temperature on the model behaviour.

Parameters

Connectors