AddAdding operational amplifier circuit |
 |
Diagram
Information
This information is part of the Modelica Standard Library maintained by the Modelica Association.
Inverting adder, based on the IdealizedOpAmpLimited model.
-vOut = k1*vIn1 + k2*vIn2
Parameters (8)
| Vps |
Value: +15 Type: Voltage (V) Description: Positive supply |
|---|---|
| Vns |
Value: -15 Type: Voltage (V) Description: Negative supply |
| V0 |
Value: 15000.0 Type: Real Description: No-load amplification |
| k1 |
Value: 1 Type: Real Description: Weight of input 1 |
| k2 |
Value: 1 Type: Real Description: Weight of input 2 |
| R |
Value: 1000 Type: Resistance (Ω) Description: Resistance at output of OpAmp |
| R1 |
Value: R / k1 Type: Resistance (Ω) Description: Calculated resistance to reach desired weight 1 |
| R2 |
Value: R / k2 Type: Resistance (Ω) Description: Calculated resistance to reach desired weight 2 |
Connectors (5)
 |
p1 |
Type: PositivePin Description: Positive electrical pin of port 1 |
|---|---|---|
 |
n1 |
Type: NegativePin Description: Negative electrical pin of port 1 |
|
p2 |
Type: PositivePin Description: Positive electrical pin of port 2 |
|
n2 |
Type: NegativePin Description: Negative electrical pin of port 2 |
|
p1_2 |
Type: PositivePin Description: Positive electrical pin 1.2 |
Components (4)
 |
opAmp |
Type: IdealizedOpAmpLimited |
|---|---|---|
 |
r1 |
Type: Resistor |
|
r2 |
Type: Resistor |
|
r |
Type: Resistor |
Used in Examples (2)
 |
Modelica.Electrical.Analog.Examples.OpAmps Inverting adder |
 |
Modelica.Electrical.Analog.Examples.OpAmps Control circuit |