This information is part of the Modelica Standard Library maintained by the Modelica Association.

An electrically excited synchronous generator is started direct on line utilizing the damper cage (and the shorted excitation winding) at 0 seconds.

At t = 0.5 seconds, the excitation voltage is raised to achieve the no-load excitation current. Note, that reactive power of the stator goes to zero.

At t = 2 second, a driving torque step is applied to the shaft (i.e. the turbine is activated). Note, that active and reactive power of the stator changes. To drive at higher torque, i.e., produce more electric power, excitation has to be adapted.

Simulate for 3 seconds and plot:

• smee.tauElectrical
• smee.wMechanical
• smee.ie
• rotorDisplacementAngle.rotorDisplacementAngle
• currentQuasiRMSSensor.I
• electricalPowerSensor.P
• electricalPowerSensor.Q
• mechanicalMultiSensor.power

Default machine parameters are used.

Note

The mains switch is closed at time = 0 in order to avoid non physical noise calculated by the rotorDisplacementAngle. This noise is caused by the interaction of the high resistance of the switch and the machine, see #2388.

VNominal	Value: 100 Type: Voltage (V) Description: Nominal RMS voltage per phase
fNominal	Value: 50 Type: Frequency (Hz) Description: Nominal frequency
Ve	Value: smeeData.Re * smeeData.IeOpenCircuit Type: Voltage (V) Description: Excitation current
gamma0	Value: 0 Type: Angle (rad) Description: Initial rotor displacement angle
smeeData	Value: Type: SynchronousMachineData Description: Synchronous machine data