Dimmer_RDimmer with resistive load |
 |
Diagram
Information
This information is part of the Modelica Standard Library maintained by the Modelica Association.
This model demonstrates the behaviour of a dimmer with phase-angle control with resistive load.
The reference voltage is prescribed by a trapezoid between zero and full voltage. The voltageToAngle block calculates the necessary phase angle, which is processed by the Signal2mPulse adaptor, applying the firing signals to the triac.
Parameters (7)
| f |
Value: 50 Type: Frequency (Hz) Description: Source frequency |
|---|---|
| Vrms |
Value: 110 Type: Voltage (V) Description: RMS source voltage |
| S |
Value: 1000 Type: ApparentPower (V·A) Description: Load apparent power |
| powerFactor |
Value: 1 Type: Real Description: Load power factor |
| ZLoad |
Value: Vrms ^ 2 / S Type: Impedance (Ω) Description: Load impedance |
| RLoad |
Value: ZLoad * powerFactor Type: Resistance (Ω) Description: Load resistance |
| LLoad |
Value: ZLoad * sqrt(1 - powerFactor ^ 2) / (2 * pi * f) Type: Inductance (H) Description: Load inductance |
Components (14)
 |
sineVoltage |
Type: SineVoltage |
|---|---|---|
 |
ground |
Type: Ground |
 |
triac |
Type: SinglePhaseTriac |
 |
voltageSensor |
Type: VoltageSensor |
 |
adaptor |
Type: Signal2mPulse |
 |
multiSensor |
Type: MultiSensor |
 |
voltageToAngle |
Type: VoltageToAngle |
 |
trapezoid |
Type: Trapezoid |
 |
meanPower |
Type: Mean |
 |
vRMS |
Type: RootMeanSquare |
 |
vH01 |
Type: Harmonic |
|
iRMS |
Type: RootMeanSquare |
|
iH01 |
Type: Harmonic |
 |
loadResistor |
Type: Resistor |