ThyristorBridge2Pulse_RLV_CharacteristicCharacteristic of two pulse Graetz thyristor bridge rectifier with R-L load and voltage |
This information is part of the Modelica Standard Library maintained by the Modelica Association.
This examples shows a two pulse full controlled bridge example with R-L load including DC voltage source. The additional DC voltage source in this example enables negative average load voltages.
Plot average voltage meanVoltage.v
versus firingAngle pulse2.firingAngle
to see control characteristic of this type of rectifier with R-L load including active voltage.
Vrms |
Value: 110 Type: Voltage (V) Description: RMS supply voltage |
---|---|
f |
Value: 50 Type: Frequency (Hz) Description: Frequency |
Vdi0 |
Value: 2 / pi * sin(pi / 2) * sqrt(2) * Vrms Type: Voltage (V) Description: Ideal max. DC voltage |
R |
Value: 20 Type: Resistance (Ω) Description: Load resistance |
L |
Value: 1 Type: Inductance (H) Description: Load resistance |
VDC |
Value: -120 Type: Voltage (V) Description: DC load offset voltage |
ground |
Type: Ground |
|
---|---|---|
sinevoltage |
Type: SineVoltage |
|
rectifier |
Type: ThyristorBridge2Pulse |
|
voltagesensor |
Type: VoltageSensor |
|
meanVoltage |
Type: Mean |
|
rootMeanSquareVoltage |
Type: RootMeanSquare |
|
currentSensor |
Type: CurrentSensor |
|
meanCurrent |
Type: Mean |
|
pulse2 |
Type: VoltageBridge2Pulse |
|
resistor |
Type: Resistor |
|
inductor |
Type: Inductor |
|
constantVoltage |
Type: ConstantVoltage |
|
ramp |
Type: Ramp |