This information is part of the Modelica Standard Library maintained by the Modelica Association.

Calculation of pressure loss in curved bends at overall flow regime for incompressible and single-phase fluid flow through circular cross sectional area considering surface roughness.

Generally this function is numerically best used for the incompressible case, where the mass flow rate (m_flow) is known (as state variable) in the used model and the corresponding pressure loss (DP) has to be calculated. On the other hand the function dp_curvedOverall_MFLOW is numerically best used for the compressible case if the pressure loss (dp) is known (out of pressures as state variable) and the mass flow rate (M_FLOW) has to be calculated. See more information.

DP = dp_curvedOverall_DP(IN_con, IN_var, m_flow)

IN_con	Type: dp_curvedOverall_IN_con Description: Input record for function dp_curvedOverall_DP
IN_var	Type: dp_curvedOverall_IN_var Description: Input record for function dp_curvedOverall_DP
m_flow	Type: MassFlowRate (kg/s) Description: Mass flow rate

DP	Type: Pressure (Pa) Description: Output for function dp_curvedOverall_DP