.Modelica.Fluid.Pipes.BaseClasses.WallFriction.PartialWallFriction.pressureLoss_m_flow_staticHead

Information

Interface

partial function pressureLoss_m_flow_staticHead
  extends Modelica.Icons.Function;
  input SI.MassFlowRate m_flow "Mass flow rate from port_a to port_b";
  input SI.Density rho_a "Density at port_a";
  input SI.Density rho_b "Density at port_b";
  input SI.DynamicViscosity mu_a "Dynamic viscosity at port_a (dummy if use_mu = false)";
  input SI.DynamicViscosity mu_b "Dynamic viscosity at port_b (dummy if use_mu = false)";
  input SI.Length length "Length of pipe";
  input SI.Diameter diameter "Inner (hydraulic) diameter of pipe";
  input Real g_times_height_ab(unit = "m2/s2") "Gravity times (Height(port_b) - Height(port_a))";
  input SI.Area crossArea = pi * diameter ^ 2 / 4 "Inner cross section area";
  input Modelica.Fluid.Types.Roughness roughness = 2.5e-5 "Absolute roughness of pipe, with a default for a smooth steel pipe (dummy if use_roughness = false)";
  input SI.MassFlowRate m_flow_small = 0.01 "Regularization of zero flow if |m_flow| < m_flow_small (dummy if use_m_flow_small = false)";
  input SI.ReynoldsNumber Re_turbulent = 4000 "Turbulent flow if Re >= Re_turbulent (dummy if use_Re_turbulent = false)";
  output SI.Pressure dp "Pressure loss (dp = port_a.p - port_b.p)";
end pressureLoss_m_flow_staticHead;