This information is part of the Modelica Standard Library maintained by the Modelica Association.
Simple model of a hall sensor, i.e. measuring the angle of the flange (w.r.t. the optional support), multiplying by the number of phases p to obtain the electrical angle, and adding a correction term i.e. the initial angle of the flange phi0.
Note that phi0 has to be set that way, that in shaft position phi0 the flux linkage of phase 1 is a maximum.
Description: = true, if support flange enabled, otherwise implicitly grounded
Description: Number of pole pairs
Value: -pi / p
Type: Angle (rad)
Description: Initial mechanical angle
SMPM at no-load