This information is part of the Modelica Standard Library maintained by the Modelica Association.

The input signal w_ref defines the reference speed in [rad/s]. Flange flange is forced to move relative to flange support according to this reference motion. According to parameter exact (default = false), this is done in the following way:

1. exact=true
   The reference speed is treated exactly. This is only possible, if the input signal is defined by an analytical function which can be differentiated at least once. If this prerequisite is fulfilled, the Modelica translator will differentiate the input signal once in order to compute the reference acceleration of the flange.
2. exact=false
   The reference angle is filtered and the second derivative of the filtered curve is used to compute the reference acceleration of the flange. This second derivative is not computed by numerical differentiation but by an appropriate realization of the filter. For filtering, a first order filter is used. The critical frequency (also called cut-off frequency) of the filter is defined via parameter f_crit in [Hz]. This value should be selected in such a way that it is higher as the essential low frequencies in the signal.

The input signal can be provided from one of the signal generator blocks of the block library Modelica.Blocks.Sources.

useSupport	Value: false Type: Boolean Description: = true, if support flange enabled, otherwise implicitly grounded
f_crit	Value: 50 Type: Frequency (Hz) Description: If exact=false, critical frequency of filter to filter input signal