PartialElementaryTwoFlangesAndSupport2

Partial model for a component with one translational 1-dim. shaft flange and a support used for textual modeling, i.e., for elementary models

Information

This information is part of the Modelica Standard Library maintained by the Modelica Association.

This is a 1-dim. translational component with two flanges and an additional support. It is used e.g., to build up elementary ideal gear components. The component contains the force balance, i.e., the sum of the forces of the connectors is zero (therefore, components that are based on PartialGear cannot have a mass). The support connector needs to be connected to avoid the unphysical behavior that the support force is required to be zero (= the default value, if the connector is not connected).

Parameters (1)

useSupport

Value: false

Type: Boolean

Description: = true, if support flange enabled, otherwise implicitly grounded

Connectors (3)

flange_a

Type: Flange_a

Description: Flange of left shaft

flange_b

Type: Flange_b

Description: Flange of right shaft

support

Type: Support

Description: Support/housing of component

Extended by (2)

Brake

Modelica.Mechanics.Translational.Components

Brake based on Coulomb friction

SupportFriction

Modelica.Mechanics.Translational.Components

Coulomb friction in support