VoltageCenterTap2mPulseControl of 2*m pulse center tap rectifier |
 |
Diagram
Information
This information is part of the Modelica Standard Library maintained by the Modelica Association.
General information about controllers is summarized in Control.
Parameters (8)
| m |
Value: 3 Type: Integer Description: Number of phases |
|---|---|
| f |
Value: 50 Type: Frequency (Hz) Description: Frequency |
| useConstantFiringAngle |
Value: true Type: Boolean Description: Use constant firing angle instead of signal input |
| constantFiringAngle |
Value: 0 Type: Angle (rad) Description: Firing angle |
| firingAngleMax |
Value: Modelica.Constants.pi Type: Angle (rad) Description: Maximum firing angle |
| useFilter |
Value: true Type: Boolean Description: Enable use of filter |
| fCut |
Value: 2 * f Type: Frequency (Hz) Description: Cut off frequency of filter |
| vStart |
Value: zeros(m) Type: Voltage[m] (V) Description: Start voltage of filter output |
Connectors (4)
 |
firingAngle |
Type: RealInput Description: Firing angle |
|---|---|---|
 |
ac |
Type: PositivePlug |
 |
fire_p |
Type: BooleanOutput[m] |
|
fire_n |
Type: BooleanOutput[m] |
Components (4)
 |
twomPulse |
Type: Signal2mPulse |
|---|---|---|
 |
delta |
Type: MultiDelta Description: Delta connection |
 |
voltageSensor |
Type: PotentialSensor Description: Voltage sensor |
 |
gain |
Type: Gain[m] |
Used in Components (1)
 |
Modelica.Electrical.PowerConverters.Examples.ACDC.ExampleTemplates Template of 2*m pulse thyristor rectifier with center tap |