HalfControlledBridge2mPulse2*m pulse half controlled rectifier bridge with resistive load |
 |
Diagram
Information
This information is part of the Modelica Standard Library maintained by the Modelica Association.
This example shows a half controlled 2*m pulse bridge rectifier with resistive load, where m is the number of phases. In case of resistive load the half controlled bridge shows the same output voltage as the
full controlled bridge.
Plot current currentSensor.i, average current meanCurrent.y, voltage voltageSensor.v and average voltage meanVoltage.v.
Parameters (5)
| m |
Value: 3 Type: Integer Description: Number of phases |
|---|---|
| Vrms |
Value: 110 Type: Voltage (V) Description: RMS supply voltage |
| f |
Value: 50 Type: Frequency (Hz) Description: Frequency |
| constantFiringAngle |
Value: 30 * pi / 180 Type: Angle (rad) Description: Firing angle |
| R |
Value: 20 Type: Resistance (Ω) Description: Load resistance |
Components (11)
 |
sineVoltage |
Type: SineVoltage |
|---|---|---|
 |
rectifier | |
 |
voltagesensor |
Type: VoltageSensor |
 |
meanVoltage |
Type: Mean |
 |
rootMeanSquareVoltage |
Type: RootMeanSquare |
 |
currentSensor |
Type: CurrentSensor |
|
meanCurrent |
Type: Mean |
 |
pulse2m |
Type: VoltageBridge2mPulse |
 |
multiStarResistance |
Type: MultiStarResistance |
 |
ground |
Type: Ground |
 |
resistor |
Type: Resistor |