ThyristorBridge2mPulse_RLV2*m pulse thyristor rectifier bridge with R-L load and voltage |
This information is part of the Modelica Standard Library maintained by the Modelica Association.
This example shows a full controlled 2*m
pulse bridge rectifier with R-L load including DC voltage source, where m
is the number of phases. The additional DC voltage source in this example enables negative average load voltages.
Plot current currentSensor.i
, average current meanCurrent.y
, voltage voltageSensor.v
and average voltage meanVoltage.v
.
m |
Value: 3 Type: Integer Description: Number of phases |
---|---|
Vrms |
Value: 110 Type: Voltage (V) Description: RMS supply voltage |
f |
Value: 50 Type: Frequency (Hz) Description: Frequency |
constantFiringAngle |
Value: 30 * pi / 180 Type: Angle (rad) Description: Firing angle |
R |
Value: 20 Type: Resistance (Ω) Description: Load resistance |
L |
Value: 1 Type: Inductance (H) Description: Load resistance |
VDC |
Value: -260 Type: Voltage (V) Description: DC load offset voltage |
sineVoltage |
Type: SineVoltage |
|
---|---|---|
rectifier |
Type: ThyristorBridge2mPulse |
|
voltagesensor |
Type: VoltageSensor |
|
meanVoltage |
Type: Mean |
|
rootMeanSquareVoltage |
Type: RootMeanSquare |
|
currentSensor |
Type: CurrentSensor |
|
meanCurrent |
Type: Mean |
|
pulse2m |
Type: VoltageBridge2mPulse |
|
multiStarResistance |
Type: MultiStarResistance |
|
ground |
Type: Ground |
|
resistor |
Type: Resistor |
|
inductor |
Type: Inductor |
|
constantVoltage |
Type: ConstantVoltage |