Friction

Use of model Stop

Diagram

Information

This information is part of the Modelica Standard Library maintained by the Modelica Association.

  1. Simulate and then plot stop1.f as a function of stop1.v This gives the Stribeck curve.
  2. The same model is also available by modeling the system with a Mass and a SupportFriction model. The SupportFriction model defines the friction characteristic with a table. The table is constructed with function Examples.Utilities.GenerateStribeckFrictionTable(…) to generate the same friction characteristic as with stop1. The simulation results of stop1 and of model mass are therefore identical.
  3. Model stop2 gives an example for a hard stop. However there can arise some problems with the used modeling approach (use of reinit(…), convergence problems). In this case use the ElastoGap to model a stop (see example Preload).

Components (9)

stop1

Type: MassWithStopAndFriction

force

Type: Force

sineForce

Type: Sine

stop2

Type: MassWithStopAndFriction

spring

Type: Spring

fixed2

Type: Fixed

force2

Type: Force

mass

Type: Mass

supportFriction

Type: SupportFriction