ThyristorBridge2Pulse_RLVTwo pulse Graetz thyristor bridge rectifier with RL load and voltage 
This information is part of the Modelica Standard Library maintained by the Modelica Association.
This examples shows a two pulse full controlled bridge example with RL load including DC voltage source. The additional DC voltage source in this example enables negative average load voltages.
Plot current currentSensor.i
, average current meanCurrent.y
, voltage voltageSensor.v
and average voltage meanVoltage.v
.
Vrms 
Value: 110 Type: Voltage (V) Description: RMS supply voltage 

f 
Value: 50 Type: Frequency (Hz) Description: Frequency 
constantFiringAngle 
Value: 30 * pi / 180 Type: Angle (rad) Description: Firing angle 
R 
Value: 20 Type: Resistance (Ω) Description: Load resistance 
L 
Value: 1 Type: Inductance (H) Description: Load resistance 
VDC 
Value: 120 Type: Voltage (V) Description: DC load offset voltage 
ground 
Type: Ground 


sinevoltage 
Type: SineVoltage 

rectifier 
Type: ThyristorBridge2Pulse 

voltagesensor 
Type: VoltageSensor 

meanVoltage 
Type: Mean 

rootMeanSquareVoltage 
Type: RootMeanSquare 

currentSensor 
Type: CurrentSensor 

meanCurrent 
Type: Mean 

pulse2 
Type: VoltageBridge2Pulse 

resistor 
Type: Resistor 

inductor 
Type: Inductor 

constantVoltage 
Type: ConstantVoltage 