PartialTwoFlangesComponent with two translational 1D flanges |
 |
Information
This information is part of the Modelica Standard Library maintained by the Modelica Association.
This is a 1D translational component with two flanges. It is used e.g., to built up parts of a drive train consisting of several base components.
Connectors (2)
Extended by (8)
 |
Modelica.Mechanics.Translational.Interfaces Device to measure a single relative variable between two flanges |
 |
PartialElementaryTwoFlangesAndSupport2 Modelica.Mechanics.Translational.Interfaces Partial model for a component with one translational 1-dim. shaft flange and a support used for textual modeling, i.e., for elementary models |
 |
PartialCompliantWithRelativeStates Modelica.Mechanics.Translational.Interfaces Base model for the compliant connection of two translational 1-dim. shaft flanges where the relative position and relative velocities are used as states |
 |
Modelica.Mechanics.Translational.Interfaces Compliant connection of two translational 1D flanges |
 |
Modelica.Mechanics.Translational.Interfaces Rigid connection of two translational 1D flanges |
 |
Modelica.Mechanics.Translational.Interfaces Partial model for a component with two translational 1-dim. shaft flanges and a support used for graphical modeling, i.e., the model is build up by drag-and-drop from elementary components |
 |
Modelica.Mechanics.Translational.Sources Input signal acting as torque on two flanges |
 |
Modelica.Mechanics.Translational.Components Definition of relative state variables |