VoltageBridge2mPulseControl of 2*m pulse bridge rectifier |
This information is part of the Modelica Standard Library maintained by the Modelica Association.
General information about controllers is summarized in Control.
Half of the semiconductors of the 2*m
pulse bridge rectifier are connected with the positive DC output pin (firing signal fire_p
). The other half of the semiconductors is connected with the negative DC output pin (firing signal fire_n
). Parameter m
indicates the number of phases.
f |
Value: 50 Type: Frequency (Hz) Description: Frequency |
---|---|
useConstantFiringAngle |
Value: true Type: Boolean Description: Use constant firing angle instead of signal input |
constantFiringAngle |
Value: 0 Type: Angle (rad) Description: Firing angle |
firingAngleMax |
Value: Modelica.Constants.pi Type: Angle (rad) Description: Maximum firing angle |
useFilter |
Value: true Type: Boolean Description: Enable use of filter |
fCut |
Value: 2 * f Type: Frequency (Hz) Description: Cut off frequency of filter |
vStart |
Value: zeros(m) Type: Voltage[m] (V) Description: Start voltage of filter output |
firingAngle |
Type: RealInput Description: Firing angle (rad) |
|
---|---|---|
ac |
Type: PositivePlug |
|
fire_p |
Type: BooleanOutput[m] |
|
fire_n |
Type: BooleanOutput[m] |
twomPulse |
Type: Signal2mPulse |
|
---|---|---|
delta |
Type: MultiDelta Description: Delta connection |
|
voltageSensor |
Type: VoltageSensor Description: Voltage sensor |
Modelica.Electrical.PowerConverters.Examples.ACDC.RectifierBridge2mPulse 2*m pulse half controlled rectifier bridge with resistive load |
|
ThyristorBridge2mPulse_DC_Drive Modelica.Electrical.PowerConverters.Examples.ACDC.RectifierBridge2mPulse 2*m pulse thyristor bridge feeding a DC drive |
Modelica.Electrical.PowerConverters.Examples.ACDC.ExampleTemplates Template of 2*m pulse rectifier with center tap |
|
Modelica.Electrical.PowerConverters.Examples.ACDC.ExampleTemplates Template of 2*m pulse bridge thyristor rectifier |